Brand

HID VertX V200 Input Monitor Interface

  1. Home
  2. HID VertX V200 Input Monitor Interface

HID VertX V200 Input Monitor Interface - Alarm Input Processing for up to 16 Zones

HID

The HID VertX Products provide a complete and fully featured hardware/firmware intrastructure for biometric access control software host systems.

The HID VertX V200 Input Monitor Interface conects upto 16 supervised input circuits. Each input point monitors and reports normal, off-normal, and alarm states. The HID VertX V200 features on-board flash memory, allowing program updates to be downloaded through the network. The HID VertX V200 connects to the v1000 via a high speed RS-485 network. The V1000, in turn. communicates with the system host via industry standard TCP/IP protocol, over 10/100 Mbps Ethernet, or the Internet. This architecture minimizes the impact on corporate LANs, by using only one TCP/IP address for every 32 interfaces, and by handling low-level transactions on the RS-485 network.

Key Benefits :
  • Reports supervised or un-supervised alarm circuits.
  • Off-normal condition programmable for each input point (NO or NC alarm devies may be used).
  • Connects to the V1000 via RS-485.
  • Receives and processes real time commands from the HID VertX V1000.
  • Reports all activity to the V1000.
  • Allows complex input/output linking when used with the HID VertX V1000 and V300 Output Control Interface.
  • Attractive polycarbonate enclosure protects components from damage.
  • All connections and indicators are fully identified by silk-screened nomendclatureon the cover.
  • UL 294 and UL 1076 recognized components.

Technical Specification :

Dimensions: 5.8"W x 4.825"H x 1.275" D (147.32 mm x 122.55 mm x 32.38 mm)
Weight: 12.4 oz (0.35 kg)
Power Supply Requirements: 50 mA @ 9-18 VDC (with no readers connected) Recommended: Supervised linear power supply with battery backup, input surge protection, and AC fail and battery low contact outputs. separate supervised DC supply with battery back-up recommended for relay activated devices.
Cable Distance:
RS-485: 4000 feet (1220 m) to host, using Belden 3105A, 22AWG twisted pair, shielded 100? cable Input Circuits-500 feet (150 m), two-conductor, shielded, using ALPHA 1292C (22AWG) or Alpha 2421C (18AWG).
Output Cirbuits: 500 feet (150 m), 2-conductor, usingALPHA 1172C (22AWG) or Alpha 1897C (18AWG) Minimum wire gauge depends on cable length and current requirements.